二步烧结法制备高密度烧结镁砂的研究

doi:10.3969/j.issn.1001-1935.2026.04.013

耐火材料 ›› 2026, Vol. 60 ›› Issue (4): 347-350.DOI: 10.3969/j.issn.1001-1935.2026.04.013

二步烧结法制备高密度烧结镁砂的研究

秦嘉晨¹⁾, 周驰¹⁾, 王春艳¹⁾, 栾舰¹⁾, 王树山²⁾

1)辽宁科技大学材料与冶金学院辽宁鞍山 114044;
2)辽宁中镁控股股份有限公司辽宁营口 115000

收稿日期:2025-08-09 出版日期:2026-08-15 发布日期:2026-08-21
通讯作者: 栾舰,男,1971年生,副教授。E-mail:jianluan@126.com
作者简介:秦嘉晨:女,2000年生,硕士研究生。E-mail:905993609@qq.com
基金资助:
2023年辽宁省“揭榜挂帅”科技计划项目(2023JH1/10400010)。

Preparation of high-density sintered magnesia by two-step sintering method

Qin Jiachen, Zhou Chi, Wang Chunyan, Luan Jian, Wang Shushan

First author’s address: School of Materials and Metallurgy, University of Science and Technology Liaoning, Anshan 114044, Liaoning, China

Received:2025-08-09 Online:2026-08-15 Published:2026-08-21

摘要/Abstract

摘要： 为了制备高密度烧结镁砂,以浮选菱镁矿精矿粉为原料,通过对浮选菱镁矿精矿粉进行物相分析、显微结构分析以及柠檬酸活性测试确定氧化镁的最佳轻烧制度;通过体积密度、显气孔率和显微结构分析确定了二步烧结制度。结果表明:浮选菱镁矿粉的最佳轻烧制度为800 ℃保温3 h,从节能和高密度两个角度考虑,二步烧结的最佳热处理条件为1 800 ℃保温3 h,可得到体积密度为3.41 g·cm^-3的高密度烧结镁砂。

关键词: 浮选菱镁矿, 高密度镁砂, 烧结性能, 显微结构

Abstract: In order to prepare high-density sintered magnesia,the concentrate powder of flotation magnesite was used as the raw material.The optimal light calcination condition of magnesia was determined via phase analysis,microstructure observation and citric acid activity test of flotation magnesite concentrate powder,and the two-step sintering procedure was confirmed by testing bulk density,apparent porosity and characterizing microstructure.The results show that the optimal light-burning system for flotation magnesite powder is holding at 800 ℃ for 3 h.From the perspectives of energy conservation and high density,the optimal two-step sintering condition is holding at 1 800 ℃ for 3 h,by which high-density sintered magnesia with a bulk density of 3.41 g·cm^-3 can be obtained.

Key words: flotation magnesite, high-density magnesia, sintering performance, microstructure

中图分类号:

TQ175

秦嘉晨, 周驰, 王春艳, 栾舰, 王树山. 二步烧结法制备高密度烧结镁砂的研究[J]. 耐火材料, 2026, 60(4): 347-350.

Qin Jiachen, Zhou Chi, Wang Chunyan, Luan Jian, Wang Shushan. Preparation of high-density sintered magnesia by two-step sintering method[J]. Refractories, 2026, 60(4): 347-350.

参考文献

[1] Guo Z Q,Ding Q,Liu L,et al.Microstructural characteristics of refractory magnesia produced from macrocrystalline magnesite in China[J].Ceramics International,2021,47(16):22701-22708.
[2] 高陟,马北越,任鑫明,等.利用菱镁矿制备先进镁质材料的研究进展[J].耐火材料,2020,54(1):88-92.
[3] Han B Q,Li Y S,Guo C C,et al.Sintering of MgO-based refractories with added WO₃[J].Ceramics International,2007,33(8):1563-1567.
[4] Fu L L,Yue J R,Liu W J,et al.Analysis and experiment of sintering and densification of magnesia particles[J].Chemical Engineering Science,2023,268:118396.
[5] Jin E D,Yu J K,Wen T P,et al.Effects of the molding method and blank size of green body on the sintering densification of magnesia[J].Materials,2019,12(4):647.
[6] Ma B Y,Ren X M.Effects of key factors on the densification and grain growth behaviour of sintered magnesia from magnesite[J].Ceramics International,2022,48(23):35525-35535.
[7] Zhang X H,Zhao L,Dong H,et al.Numerical investigation of gas-solid heat transfer process and parameter optimization in shaft kiln for high-purity magnesia[J].Chemical Engineering Research and Design,2023,193:576-586.
[8] 崔妍,刘新,曲殿利.添加La₂O₃对低品位菱镁矿制备烧结镁砂的影响[J].耐火材料,2020,54(5):441-443.
[9] Kumar P,Burhanuddin,Kumar A,et al.Effect of titania on the microstructure evolution of sintered magnesite in correlation with its properties[J].Ceramics International,2015,41(7):9003-9008.
[10] 周玉军,唐大才,温天朋,等.利用盐湖老卤制备高性能烧结镁砂的研究[J].耐火材料,2025,59(2):162-166.
[11] 李环,于景坤,匡世波.菱镁矿轻烧水化对MgO烧结的影响[J].耐火材料,2008,42(2):92-96.
[12] Guan H B,Wang P,Wang H,et al.Preparation of nanometer magnesia with high surface area and study on the influencing factors of the preparation process[J].Acta Physico-Chimica Sinica,2006,22(7):804-807.
[13] Wang Q Q,Dai S J,Xi Y.Preparation of magnesia from hydromagnesite ore by calcination[J].JOM,2021,73(3):856-861.
[14] 郭玉香,彭强,曲殿利,等.轻烧氧化镁活性对镁砂烧结性能及显微结构的影响[J].耐火材料,2018,52(3):176-179.
[15] 岳静静,赵鑫,游杰刚,等.硅粉、石墨加入量对菱镁矿尾矿制备镁质复合材料性能的影响[J].耐火材料,2025,59(3):203-207.

二步烧结法制备高密度烧结镁砂的研究

Preparation of high-density sintered magnesia by two-step sintering method

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	刘兴颜, 陈平安, 乔梦珂, 陈浮, 吴江, 李享成. 六铝酸钙-镁铝尖晶石复相材料的制备及性能研究[J]. 耐火材料, 2026, 60(2): 98-102.
[2]	张文坷, 李素平, 晋一, 何思瑶, 马成良, 刘新红, 冯润堂, 田晓利, 刘百宽. α-Al₂O₃微粉加入量对镁质坩埚材料结构与性能的影响[J]. 耐火材料, 2026, 60(2): 103-107.
[3]	张军, 余海丽, 张三华, 曹壮, 周慧君, 张志华. 高碳铬铁渣加入量对高铝耐磨浇注料结构与性能的影响[J]. 耐火材料, 2026, 60(2): 118-123.
[4]	肖扬武, 马骁一, 熊继全, 张晓存, 聂建华, 梁永和, 鞠茂奇, 孙惠东. Fe₂O₃对转炉用镁质水系大面料性能的影响[J]. 耐火材料, 2026, 60(2): 136-140.
[5]	王世贞, 韩兵强, 谭丹, 魏耀武, 鄢文, 李楠. 电熔镁砂对钙长石-尖晶石隔热耐火材料性能的影响[J]. 耐火材料, 2026, 60(1): 1-7.
[6]	孙格格, 李国华, 邓舒丹, 田琳. 轻量化镁砂制备水泥窑烧成带用方镁石-铁铝尖晶石材料[J]. 耐火材料, 2026, 60(1): 13-18.
[7]	陈嘉良, 丁军, 罗益欣, 刘正龙, 余超, 朱青友, 邓承继. 隔热碳纤维复合材料微纳孔调控及其性能[J]. 耐火材料, 2026, 60(1): 48-53.
[8]	吴嵩, 韦龙杰, 王建筑, 陈继, 袁愈辉, 刘诚. 无水硼砂对Al₂O₃-C复合材料性能与显微结构的影响[J]. 耐火材料, 2026, 60(1): 65-68.
[9]	郭会师, 高朝阳, 李文凤, 杨佳麟, 周超杰, 秦笑梅, 秦肖雲, 侯佩, 陈凤华, 桂阳海, 刘应凡. 固废煤矸石制备钙长石隔热耐火材料的结构与性能研究[J]. 耐火材料, 2025, 59(6): 461-465.
[10]	王采燃, 侯庆冬, 于佳瑶, 高慧楠, 边作民, 罗旭东, 何鑫叶, 李一涵. 利用中烧镁砂制备MgO-Mg₂SiO₄质耐火材料及抗热震性能研究[J]. 耐火材料, 2025, 59(6): 482-487.
[11]	欧阳李, 杨爽, 顾华志. 多尺度级配的氧化铝对氧化铝坩埚性能的影响[J]. 耐火材料, 2025, 59(6): 495-499.
[12]	黄家旭, 齐建玲, 吕学明, 刘亚东. 碳化电炉用镁碳砖的侵蚀分析[J]. 耐火材料, 2025, 59(6): 516-520.
[13]	戴晨晨, 钱凡, 赵进宣, 杨健, 聂波华. 转炉热态修补料烧结性能评价与优化研究进展[J]. 耐火材料, 2025, 59(5): 444-449.
[14]	程庆楠, 潜坤, 陈波, 王建军, 刘奎. 基于正交设计优化镁铝尖晶石性能[J]. 耐火材料, 2025, 59(3): 198-202.
[15]	杜娟, 李文凤, 郭会师, 申天姿, 石凯, 曹骏. 锆刚玉添加量对Al₂O₃-SiC-C材料结构和性能的影响[J]. 耐火材料, 2025, 59(3): 208-212.